On-Site Steel Cutting
Torch and plasma cutting that comes to you. We cut steel to size, cut off worn and broken parts, and heat stuck pieces loose right where your equipment is parked, so nothing gets hauled anywhere first.
Plasma and torch, both on the truck
The rig carries a Hypertherm 45 plasma cutter and a full oxy-acetylene torch setup, backed by a portable band saw and grinders. Plasma gives quick, clean cuts through sheet, flat bar and plate. The torch takes on the heavy pieces, up through the 3/4 to 1 inch steel we handle regularly, and it's also our heat for bending and loosening parts.
The first step of a lot of repairs
On a CAT 325 excavator bucket in Tuolumne County, the worn teeth came off with the torch before anything new went on. The mounts were then ground back to clean metal and fresh teeth were welded in place. Cutting on site means the machine stays where it works, and the repair starts the moment the truck parks.
What we cut
If it's steel and it's worn out, in the way or the wrong size, the torch or the plasma cutter handles it.
- Flat bar, angle and plate cut to length
- Worn bucket teeth, cutting edges and wear parts
- Old hitches, brackets and mounts
- Damaged sections cut out for new steel
- Seized pins and bolts heated loose
- Bent parts heated and pulled straight
- Holes, slots and notches in plate
- Retired equipment and trailers cut down for hauling
Cut where it sits, or cut for the build
Most cutting happens right where the steel is: on the machine, on the trailer or out at the ranch. When the cut pieces are headed into something new, they go from the cutter to the fabrication table and get fit and welded into the finished part.
From recent jobs
What our customers say
Emmit showed up early, was professional, made some perfect welds, cleaned up any mess left over afterwards, and the welds are holding up superbly.
Hired Emmit to put some new brackets on my brush guard bumper. Showed up right when he said he would, and did an amazing job.
Emmit shows up on time and does quality work at a reasonable price.
Our Recent Work
Swipe left or right to see additional projects or click on any project to see complete project details
Questions we hear
Can you cut steel on site?
Yes. The plasma cutter and the torch both ride on the truck, so we cut at your equipment, trailer or jobsite without anything being hauled in.
Torch or plasma: which one do I need?
You don't have to decide. Plasma is quick and clean on thinner steel. The torch cuts thick plate and heavy parts, and it's the tool for heating seized or bent pieces. Plenty of jobs use both.
Can you cut steel to size for a project?
Yes. Send us the measurements, or we'll measure on site, and we'll cut flat bar, angle, channel, tube and plate to the sizes you need.
Are you certified?
Yes. Our welding is AWS certified: MIG 3G, flux core 3G on 0.045 212 wire, and dual shield 1G through 4G on 0.045 E71T wire.
What hours do you work?
Regular hours are 8 to 5, Monday through Friday. After-hours and emergency call-outs are available 24 hours a day, Monday through Saturday, and are quoted up front. Call or text us to schedule.
Need steel cut?
Send a photo of what needs cutting and where it sits, and we'll call back with a plan and a price.